How To Repair An Alarm Motion Sendor

Quick guide to moving an alert PIR sensor If you're decorating your house or doing some abode renovations and demand to move a PIR alarm sensor, then

Quick guide to moving an alert PIR sensor

If you're decorating your business firm or doing some domicile renovations and need to movement a PIR warning sensor, then the skillful news is that it's relatively straight-forward to exercise.

Here'southward our quick guide to removing / replacing an alarm PIR sensor:

• Remove the PIR sensor chapeau – unremarkably by unscrewing a single screw under the lesser of the sensor
• If there's a plastic 'lens' inside the sensor, carefully remove this likewise – as otherwise it's likely to fall out
• Loosen the excursion board, just unscrewing a unmarried spiral
• Remove all wires (N.B. normally there will exist x6 wires). Please note, you must not touch we recommend putting some tape over each of the wire ends – especially the red and blackness wires – otherwise you are likely to short the warning, and potentially blow a fuse / pause the system.
• Finally unscrew the backplate of the PIR sensor. You're now done!

Due north.B.1 when you disconnect the wires from the sensor if you take a tamper zone wired in, then this will gear up the alarm off. Simply enter your code to terminate the alarm. At this betoken a 'tamper alarm' will announced on your alarm.

N.B.2 if you want to carry on using your alarm system, you'll have to 'OMIT' the zone that yous've just removed, otherwise the alarm won't gear up / work (see notes below on how to get your system working again).

The good news is that moving a sensor is relatively easy. That said, moving a sensor isn't without its risks – as if y'all want to continue the rest of your alarm working, y'all'll need to keep power to the organization – meaning that there'll all the same be 12V running through the wires, which you need to make sure you don't brusque – otherwise this could affect the residuum of your alarm system.

More in-depth notes on removing a PIR movement sensor (& video guide)

To remove or replace a PIR alarm sensor, showtime you demand to remove sensor chapeau (normally requiring unscrewing a single screw) and plastic lens encompass inside (if nowadays). N.B. this will ready the warning off. To silence alarm, enter 4 digit code (a tamper message should appear).

Once within the sensor yous demand to loosen the screw securing the circuit board.

Delight annotation – you lot need to make certain that the positive / negative ability wires don't touch – as this will short the alarm, blowing a fuse.

To fully remove the sensor you and then need to unscrew the backplate from the wall and remove the wire. Do the opposite to re-fit.

How to proceed using alarm system once PIR sensor is removed

Once you've removed your sensor, as noted above a 'tamper alarm' will go off. To enable you lot to set / unset the alarm as normal yous need to 'OMIT' a zone. To do this, you demand to follow the instructions of your alert panel (you can Google this) – in general omitting a zone is relatively directly-forward.

Still, need help?

If yous still need aid with your warning, and then make it contact with our squad to see if we tin can assistance you >>

Or if y'all know y'all need an engineer then book an 'on-site visit' where ane of our trained engineers comes out to your site to fix your problem.  Book an engineer visit here  or email u.s. at help@smartsecurity.back up

Source: https://www.smartsecurity.guide/how-to-remove-replace-alarm-pir-sensor/

Posted by: hernandezdoull1950.blogspot.com

Share this post